Planetary reducer in the use of the process of three matters needing attention

Time：2020-05-24

Planetary reducer is suitable for a wide range of industries, is a series of reducer, but in order to operate in the future safety and prolong the service life of planetary reducer machine, in the process of use must pay attention to the following points:

1. The planetary reducer must be equipped with a ventilation cap
Before use, the highest blockage should be replaced with exhaust plug, to ensure that the reducer in operation when the exhaust gas body. If it is not replaced in time, the reducer will run for a long time, and the gas in the reducer will swell and break, and the reducer will leak oil.

2. Planetary reducer is strictly prohibited from hammering
Reducer output shaft installed, coupling, belt pulley, sprocket and other connecting parts can not use direct hammering method, because the output shaft structure of the reducer can not bear axial hammering, available shaft end screw screw screw pressure into the connection.

3. Replace the lubricating oil in time for the planetary reducer, and pay special attention to the first time.
Special attention should be paid to the oil change for the first time, the reducer should be replaced in time after the first 300 ~ 400 hours of operation, and the lubricating oil should be replaced every 1500 ~ 2000 hours. In addition, in bad working environment, high temperature, dust should be every half a month to check the lubricating oil, found that the lubricating oil is dirty that is to replace the lubricating oil, in order to keep the lubricating oil clean, prolong the service life of the reducer, improve economic benefits.

To change the oil means to remove all the previous oil, rinse it off, and then add the new oil.

Last：What are the factors that affect the efficiency of the reducer?
Next：Correct installation and use of planetary gear reducer